When an industrial robot already stands at the plant, "buy a new cell or not" is not always the best question. Sometimes it is better to keep the working manipulator and add what it lacks for your task. This is what we call Inducoat Retrofit.
Why upgrade at all
An old robot is usually mechanically sound and expensive to replace. What it lacks is typically not "muscle" but "vision and planning": it repeats a recorded program, but it does not see the part and cannot build motion for a new geometry on its own. So every new part means new programming, which takes the time of a skilled specialist and idles the installation.
What stays unchanged
- The manipulator. We do not propose replacing it.
- The robot's own controller. It keeps running the motion program. We do not substitute the motion control system.
- The industrial safety circuit. It works independently of our software and does not depend on it.
This is a matter of principle: safety must not depend on a program that we write.
What is added
A layer that an older installation usually does not have:
- 3D scanning of the part. The installation gets the geometry of the real part, not only a recorded point.
- Automatic toolpath planning. Our software calculates the motion and the painting parameters for the specific geometry, and the controller runs the finished program.
- Digital records. Parameters, recipes and a log of every cycle are stored. With pressure and flow sensors, material consumption can be tracked.
The goal is the same as for a new cell: not to write a program by hand for every new part and to have repeatable settings.
When Retrofit does not fit
Not every installation can be upgraded, and it is better to say so at once. Retrofit may make no sense if:
- the controller or its software version does not allow connecting external planning;
- the robot's reach zone is too small for your parts;
- the installation itself is worn to the point that investment is not justified;
- the task is not painting with liquid coating materials, on which the first version of our cell is built.
That is why we talk only about compatible installations and assess each separately.
What to find out before the first conversation
- The robot model and the controller version.
- Which parts and materials it is used for.
- Whether there is spray equipment, a PLC and sensors, and what condition they are in.
- Whether the reach zone is enough for your parts.
- Who sets up the installation now and how long it takes for a new part.
The answers decide whether Retrofit is appropriate at all. That is why we agree terms, timing and cost for each plant instead of naming them in advance.
Where we are
The project is at R&D stage: the architecture of the cell is designed, and we have not built the physical cell yet. You can see the principle in Inducoat Studio: it is a geometric simulation that is not connected to real equipment. If you have a robot that could be a candidate for an upgrade, write to us.