UA Send a request

← All articles

Why the coating comes out different from shift to shift

The same part, the same paint, the same equipment. On the morning shift the coating lies evenly, on the evening shift runs, misses and stripes appear. There is usually no better painter and worse painter in this story. There is a manual process in which several important parameters are slightly different every time, and a person cannot keep them identical for a whole shift.

What exactly sets film thickness

Layer thickness depends on how much material lands on a unit of area, and that is made of several things at once:

  • Distance from the gun to the surface. When the gun is closer, the layer is thicker and the fan narrower. When it is farther, the fan is wider, but part of the material scatters and flies past the part.
  • Speed of the hand. Slower movement means more material per area. Faster gives a thinner layer. Toward the end of a shift the speed almost always drifts a little.
  • Overlap of passes. Each next pass has to overlap the previous one by a constant part of the fan width. If the overlap is different every time, stripes show on the surface.
  • Gun angle. On a flat area it is easy to hold. On corners, edges and complex areas the hand turns the gun, and the surface gets a different amount of material.
  • Things that do not depend on the person: pressure, material viscosity, booth temperature. They also have to be kept stable, but that is a separate topic.

A painter adjusts each of the first four by eye and by feel. An experienced one does it well. But well does not mean identically: quality depends on fatigue, on how convenient the part stands, and on how many such parts have already passed during the shift.

Why this is expensive

Thickness scatter is not always visible at once. Many defects appear only after curing: runs, thin spots where the substrate shows, over-thick areas that later crack. It can be fixed only by sanding and repainting. Then you pay twice, for material and for a person's time, and the part is also delayed in the flow.

Overuse is a separate matter. To be sure of leaving no thin spots, a painter often applies with a margin, which again costs material.

What a motion program gives

When the motion of the gun is set by a program, distance, speed and overlap stop being a feeling and become parameters. They can be recorded, repeated for the next part, changed deliberately and compared between two settings. Identical parts follow an identical path at an identical speed.

This does not mean automation necessarily paints better than the best painter. It removes the scatter between shifts and between people. For a plant with repeated parts that often matters more than the peak quality of a single part.

What we are developing

We are developing a cell in which toolpaths are calculated from a 3D scan of the real part. The idea is that a new part does not have to be programmed by hand and that painting settings stay repeatable. The target result: a steadier coating and fewer repeated operations.

This is a design goal. The physical cell is not built yet, so we do not say by how much the thickness scatter will shrink: only a trial on real equipment and real parts can show that.

How to see what we mean

In Inducoat Studio you can pick a part, run the simulation of scanning and painting, and look at the film thickness map: where the layer is sufficient, where it is thinner and how that changes with speed and overlap. It is a geometric simulation of our concept, not a measurement at a plant.

Where to start the conversation

If you paint repeated parts, it helps to know the answers to these questions for yourself:

  1. Which parts, and in what volumes, do you paint most often?
  2. What share of your painting is repeated, and which defects occur most?
  3. Does quality change between shifts and between operators?
  4. What coating thickness requirements must you meet?

With these answers we can discuss whether a pilot on your part makes sense and what should be measured in it.